EN10210 S275J2H Hot Finished RHS,SHS and CHS Hollow Sections

S275J2H hollow sections supplied by Beverly Steel Malaysia ranging from low temperature RHS-Rectangular Hollow Section, SHS-Square Hollow Section, CHS-Circular Hollow Section to special big or large sizes hollow sections from various countries of Euthyroid thyroid condition Buy Synthroid origin. The entire range of S275J2H hollow sections comply fully to EN Standard for hot formed structural hollow sections, EN10210: S275J2H, dimensions and Oleogranulema penis Properties comply to EN10210-1, Tolerance complies to EN10210-2 with a minimum yield strength of 275 N mm², -20 degree C at 27joules.

Application : Transmission Tower Projects, Oil and Gas Projects, Power Plants, Sugar Plants, Cranes, MRT-Mass Rapid Transit, MTR-Mass Transit Railway, Terminals, Stations, Bus Stop, Sea Port Facilities, Air Port Facilities, Structural Design Arts for Buildings and Towers, Structural Support for Building and Facilities Expansion, Transport Vehicles, Automotive, Theme Parks, Structural for Theme Park Rides and etc...

Nearest Equivalent : DIN 17100 ST44-3N, DIN 17123/4/5 ST44.3N, BS4360 Gr43D,

UNI 7806 Fe 430D, NF A 35501 E 28-4, NF A 49501 E 28-4.

S275J2H

– block letter "S" means "STEEL FOR STRUCTURAL APPLICATIONS"

– the next figure means the minim. yield value required for wall thickness ≤ 16 mm

– "J2" means impact test value -20° C min. 27 joules

– block letter "H" means "HOLLOW SECTION"

The following typical tables concern chemical and mechanical properties

CHEMICAL ANALYSIS
Norm		C% max Nominal W.T. (mm) ≤ 40		SI % max	Mn % max > 40	P % max	S % max	N % max
Acc.to EN 10027/1 and IC 10	Acc.to EN10027/2	C% max Nominal W.T. (mm) ≤ 40
Acc.to EN 10027/1 and IC 10	Acc.to EN10027/2		≤ 65
S275J2H	1.0138	0.20	0.22	-	1.50	0.035	0.035	-

MECHANICAL PROPERTIES
Norm		Yield strength			Tensile strength		Min. elongation L_o= 5,56 So				Min.percent. properties
Acc.to EN 10027/1 and IC 10	Acc.to EN10027/2	Nominal W.T. mm			Nominal W.T. mm		Longit. Cross Nominal W.T. mm				Test Temperature ºC	Average min. impact value
		≤ 16	> 16 ≤ 40	> 40 ≤ 65	< 3	≤ 3 ≤ 65	Longit. Cross Nominal W.T. mm
					< 3	≤ 3 ≤ 65	≤ 40	> 40 ≤ 65	> 40 ≤ 40	≤ 65
					430 - 580	410-560	≤ 40	> 40 ≤ 65	> 40 ≤ 40	≤ 65
S275J2H	1.0138	275	265	255	430 - 580	410-560	22	21	20	19	-20	27J